Differences

This shows you the differences between two versions of the page.

--- en:goflex_hems:introduction [2018/10/05 13:31] – ↷ Page moved from hiq_energy:goflex_hems:introduction to en:goflex_hems:introduction goran.kocjancic
+++ en:goflex_hems:introduction [2019/08/14 10:49] (current) – ↷ Links adapted because of a move operation goran.kocjancic
@@ Line 20: / Line 20: @@
 ===== Control system =====
-It consists of an advanced HEMS controller ([[hiq_energy:goflex_hems:hardware:hc-iq-hems|HC-IQ-HEMS]]), a suitable power supply ([[hiq_energy:goflex_hems:hardware:ps-iq|PS-IQ]]), and communication interfaces for meters, and consumer management devices ([[hiq_energy:goflex_hems:hardware:cad-232-a2-iq|CAD-232-A2-IQ]], [[hiq_energy:goflex_hems:hardware:gw-wn-w|GW-WN-W]] and [[hiq_energy:goflex_hems:hardware:gw-eno-iq|GW-ENO-IQ]]).
+It consists of an advanced HEMS controller ([[en:hiq_hw:hc-iq-hems|HC-IQ-HEMS]]), a suitable power supply ([[en:goflex_hems:hardware:ps-iq|PS-IQ]]), and communication interfaces for meters, and consumer management devices ([[en:goflex_hems:hardware:cad-232-a2-iq|CAD-232-A2-IQ]], [[en:hiq_hw:gw-wn-w|GW-WN-W]] and [[en:hiq_hw:gw-eno-iq|GW-ENO-IQ]]).
 ===== Sources and consumers measurements =====
-The measurement of electrical power and energy is provided by single-phase ([[hiq_energy:goflex_hems:hardware:pm1-e-d|PM1-E-D]]) and three-phase ([[hiq_energy:goflex_hems:hardware:pm3-i-d|PM3-I-D]]) meters, which are connected directly to [[hiq_energy:goflex_hems:hardware:cad-232-a2-iq|CAD-232-A2-IQ]] or via a wireless bridge ([[hiq_energy:goflex_hems:hardware:br-wn-w|BR-WN-W]]) to the HEMS controller.
+The measurement of electrical power and energy is provided by single-phase ([[en:goflex_hems:hardware:pm1-e-d|PM1-E-D]]) and three-phase ([[en:goflex_hems:hardware:pm3-i-d|PM3-I-D]]) meters, which are connected directly to [[en:goflex_hems:hardware:cad-232-a2-iq|CAD-232-A2-IQ]] or via a wireless bridge ([[en:hiq_hw:br-wn-w|BR-WN-W]]) to the HEMS controller.
 ===== Load managers =====
-Are used for control of managed device. Wired load managers (relays, power-relays) are toggling power supply or enabling signal for the operation of the device. They are controlled directly from [[hiq_energy:goflex_hems:hardware:hc-iq-hems|HC-IQ-HEMS]].
+Are used for control of managed device. Wired load managers (relays, power-relays) are toggling power supply or enabling signal for the operation of the device. They are controlled directly from [[en:hiq_hw:hc-iq-hems|HC-IQ-HEMS]].
 HEMS also enables the use of various wireless load management devices:
-  * Wireless socket [[hiq_energy:goflex_hems:hardware:sc1-wn-f|SC1-WN-F]],
+  * Wireless socket [[en:hiq_hw:sc1-wn-f|SC1-WN-F]],
-  * Wireless relay [[hiq_energy:goflex_hems:hardware:rl1-wn-w|RL1-WN-W]],
+  * Wireless relay [[en:hiq_hw:rl1-wn-w|RL1-WN-W]],
-  * Wireless DIN rail power meter [[hiq_energy:goflex_hems:hardware:pm1-wn-d|PM1-WN-D]] and
+  * Wireless DIN rail power meter [[en:hiq_hw:pm1-wn-d|PM1-WN-D]] and
-  * Wireless on wall power meter [[hiq_energy:goflex_hems:hardware:pm1-wn-w|PM1-WN-W]],
+  * Wireless on wall power meter [[en:hiq_hw:pm1-wn-w|PM1-WN-W]],
 which in addition to switching, also measure the consumption of these so there is no need for additional power meter.
 ===== Control devices =====
-Are used for manual control of managed devices. Push-buttons are directly wired to HEMS controller, but also wireless push-buttons ([[hiq_energy:goflex_hems:hardware:pb-eno|PB-ENO]]) are supported.
+Are used for manual control of managed devices. Push-buttons are directly wired to HEMS controller, but also wireless push-buttons ([[en:hiq_hw:pb-eno|PB-ENO]]) are supported.
 ===== Sensors =====
@@ Line 45: / Line 45: @@
 Sensors captures additional information about controlled devices, which can help optimization of load management.
 Supported sensors are:
-  * Room temperature and humidity sensor ([[hiq_energy:goflex_hems:hardware:ts-h|TS-H]])
+  * Room temperature and humidity sensor ([[en:hiq_hw:ts-h|TS-H]])
-  * 12 temperature sensors  [[hiq_energy:goflex_hems:hardware:s-pt1000|S-PT1000]] connected to [[hiq_energy:goflex_hems:hardware:air-12|AIR-12]]
+  * 12 temperature sensors  [[en:hiq_hw:s-pt1000|S-PT1000]] connected to [[en:hiq_hw:air-12|AIR-12]]
-  * Wireless room temperature and humidity sensor ([[hiq_energy:goflex_hems:hardware:tsh-wn-w|TSH-WN-W]])
+  * Wireless room temperature and humidity sensor ([[en:hiq_hw:tsh-wn-w|TSH-WN-W]])
-  * Wireless module which allows to connect up to 2 temperature probes and 2 digital signals ([[hiq_energy:goflex_hems:hardware:tdi-wn-w|TDI-WN-W]])
+  * Wireless module which allows to connect up to 2 temperature probes and 2 digital signals ([[en:hiq_hw:tdi-wn-w|TDI-WN-W]])
 {{ hiq_energy:goflex_hems:hardware:hems_sch.png?nolink |}}