Differences

This shows you the differences between two versions of the page.

--- en:hems:methods_resources:manufacture [2018/11/05 14:10] – [PM1-E-D] saso_santelj
+++ en:hems:methods_resources:manufacture [2020/07/02 07:09] (current) – [PM1-E-D] amra.begic
@@ Line 8: / Line 8: @@
 Modbus settings for supplied power-sensors: **9600 8n2; ID: 149**
-==== PM1-E-D ====
+==== PM1-E-D and PM3-E-D ====
-Factory setting: **2400 8n1; ID: 1**
+Factory setting: **2400 8n1; ID: 1; Ct: 5**
-<wrap hi>Put power-sensor in set mode by pressing button until **-SET-** is displayed on power-sensor display.</wrap>
+<wrap hi>Put power-sensor (PM1-E-D) in set mode by pressing button until **-SET-** is displayed on power-sensor display.</wrap>
 |   Parameter        |  Address (hex)  |  Format  |  Default value (hex)     |    New value (hex)         |
@@ Line 18: / Line 18: @@
 | Sensor ID          |  40021 (00 14)  |  float   |  1 (3F 80 00 00) = 1     |  149 (43 15 00 00) = 149   |
 | Baud Rate          |  40029 (00 1C)  |  float   |  0 (00 00 00 00) = 2400  |    2 (40 00 00 00) = 9600  |
+| Ct- Primary cuurent|  40051 (00 32)  |  float   |  5 (40 A0 00 00) = 5     |   50 (42 48 00 00) = 50 or 100 (42 C8 00 00) = 100 |
 CyBro-2-230-E configuring SW: {{ :hiq_energy:hems:methods_resources:eastron_config.zip |}}