Differences

This shows you the differences between two versions of the page.

--- en:hems_v1_2_0:methods_resources:firmwareupdate [2021/10/27 12:22] – [CyBroBinLoader software] neoxy
+++ en:hems_v1_2_0:methods_resources:firmwareupdate [2021/10/28 13:22] (current) – neoxy
@@ Line 4: / Line 4: @@
 ===== CyBroBinLoader software =====
-  * Download latest CyBroBinLoader.exe from www.cybrotech.com
+  * Download latest CyBroBinLoader.exe from https://www.cybrotech.com/software-category/tools/
+  * Run CybroBinLoader.exe
+  * In case Windows OS is blocking execution, click on "more info" and "run anyway"
-{{ hiq_energy:hems_v1_2_0:cybrobinloader.png?nolink&0x120        }}
+{{ hiq_energy:hems_v1_2_0:cybrobinloader.png?nolink&0x140        }}
 <WRAP clear></WRAP>
@@ Line 12: / Line 14: @@
 <WRAP pagebreak></WRAP>
-===== Applications =====
+===== Firmware upload =====
-  * Replacement for RS485 wiring solution with wireless. Optimal for long range Modbus RTU serial communications with half duplex configuration.
+  * Download latest HEMS firmware from [[en:hems_v1_2_0:download|Download]]
+  * Select correct Cybro NAD (sticker on top or side of MC controller)
+  * Select firmware under PLC program
+  * Enable PLC program and Start PLC
+  * Click send
+  * :!: PC must be on the same network as MC controller
+  * :!: Do not interrupt durring update process
+  * :!: HEMS configuration may be lost, use BACKUP before update and later RESTORE as described under [[en:hems_v1_2_0:software#settings|Software]]
+{{ hiq_energy:hems_v1_2_0:cybrobinloader_selectnad.png?nolink }}
+{{ hiq_energy:hems_v1_2_0:cybrobinloader_firmware.png?nolink }}
-</WRAP>
 <WRAP clear></WRAP>
-===== Installation and mounting =====
-  * :!: Carefully open WM-1 module and configure serial communication with jumpers. (Default configuration is 9600bps, 8N1 with normal timeout)
-  * :!: Place WM-1 module at least 10cm from other objects. Installation is not recommended inside metal cabinets.
-  * Connect RS485 terminals to WM-1 RS485 terminals
-    * A - A
-    * B - B
-    * C - GND
-  * Connect to 230V power supply
-  * Configure radio pairing
-{{ hiq_hardware:wm1_module_diagram.png?nolink&0x500  }}
-{{ hiq_hardware:wm1_mounting.png?nolink&0x500  }}
-<WRAP pagebreak></WRAP>
-===== Features =====
-  * replacement for RS485 wiring
-  * Modbus RTU serial protocol
-  * wired/wireless combinations
-  * very long range, no hopping
-  * protected private connection
-  * multiple slaves per device
-  * multiple addressable groups