Differences

This shows you the differences between two versions of the page.

--- en:hems_v1_2_0:methods_resources:firmwareupdate [2021/10/28 09:37] – neoxy
+++ en:hems_v1_2_0:methods_resources:firmwareupdate [2021/10/28 13:22] (current) – neoxy
@@ Line 4: / Line 4: @@
 ===== CyBroBinLoader software =====
-  * Download latest CyBroBinLoader.exe from www.cybrotech.com
+  * Download latest CyBroBinLoader.exe from https://www.cybrotech.com/software-category/tools/
   * Run CybroBinLoader.exe
-  * In case Windows OS is blocking execution, click on more info and run anyway
+  * In case Windows OS is blocking execution, click on "more info" and "run anyway"
 {{ hiq_energy:hems_v1_2_0:cybrobinloader.png?nolink&0x140        }}
@@ Line 16: / Line 16: @@
 ===== Firmware upload =====
-  * Download latest HEMS firmware from:  en:hems_v1_2_0:download
+  * Download latest HEMS firmware from [[en:hems_v1_2_0:download|Download]]
-  * Select correct Cybro NAD (sticker on top of MC controller)
+  * Select correct Cybro NAD (sticker on top or side of MC controller)
   * Select firmware under PLC program
   * Enable PLC program and Start PLC
   * Click send
+  * :!: PC must be on the same network as MC controller
   * :!: Do not interrupt durring update process
+  * :!: HEMS configuration may be lost, use BACKUP before update and later RESTORE as described under [[en:hems_v1_2_0:software#settings|Software]]
 {{ hiq_energy:hems_v1_2_0:cybrobinloader_selectnad.png?nolink }}
 {{ hiq_energy:hems_v1_2_0:cybrobinloader_firmware.png?nolink }}
 <WRAP clear></WRAP>
-===== Installation and mounting =====
-  * :!: Carefully open WM-1 module and configure serial communication with jumpers. (Default configuration is 9600bps, 8N1 with normal timeout)
-  * :!: Place WM-1 module at least 10cm from other objects. Installation is not recommended inside metal cabinets.
-  * Connect RS485 terminals to WM-1 RS485 terminals
-    * A - A
-    * B - B
-    * C - GND
-  * Connect to 230V power supply
-  * Configure radio pairing