Differences

This shows you the differences between two versions of the page.

--- en:hiq_hw:wm-1 [2021/10/21 13:39] – [Connection check] neoxy
+++ en:hiq_hw:wm-1 [2022/12/02 13:48] (current) – [Create new secure group] saso_santelj
@@ Line 31: / Line 31: @@
     * C - GND
   * Connect to 230V power supply
-  * Configure radio pairing
+  * Bind modules to wireless network
 {{ hiq_hardware:wm1_module_diagram.png?nolink&0x500  }}
@@ Line 77: / Line 77: @@
 {{ hiq_hardware:wm1_serial.png?nolink&0x500  }}
-===== Radio configuration =====
+===== Wireless binding =====
 ==== Create new secure group ====
-  * turn on all devices as the same time
+  * turn on all devices at the same time
   * within 10 seconds, while RF LED is blinking, press and hold button on one of the devices
   * after a second, the new address is randomly generated and sent to all devices. RF LED will blink 3 times to confirm the new address.
@@ Line 120: / Line 120: @@
-{{ hiq_hardware:wm1_connectioncheck.png?nolink&0x200  }}
+{{ hiq_hardware:wm1_connectioncheck.png?nolink&0x150  }}
 ===== Factory reset =====
@@ Line 127: / Line 127: @@
   * Other devices will not be affected.
-{{ hiq_hardware:wm1_factoryreset.png?nolink&0x500  }}
+{{ hiq_hardware:wm1_factoryreset.png?nolink&0x200  }}