User Tools

Site Tools


en:ms_main:hiq_lighting:introduction

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
en:ms_main:hiq_lighting:introduction [2020/04/18 08:34] marjan_strnaden:ms_main:hiq_lighting:introduction [2020/04/25 15:53] (current) – removed marjan_strnad
Line 1: Line 1:
-====== HIQ Lighting Control – HIQ LCS Introduction ====== 
- 
-HIQ LCS is a system of integrated devices and software that is targeted for lighting automation. 
-The primary function is control and management of any lights – on/off, dimmable, LED RGB, LED stripes using local wired or wireless push or touch buttons, Wi-Fi tablets, Mobile phones or BMS/SCADA monitoring and control. Lights can be controlled by scenarios, scheduled, by motion sensors using direct relay modules, DALI, DSI or PWM/Triac dimmable and LED stripes. Although the basic concept of HIQ LCS is simple, the possibility to extend current capabilities or add new is unlimited. 
- 
-===== HEMS Controller ===== 
- 
-It consists of an HEMS master controller ([[en:hiq_hw:mc-230|MC-230]]).  
- 
-<WRAP pagebreak></WRAP> 
- 
-===== Power sensors ===== 
- 
-The measurement of electrical power and energy of all energy sources and main electrical consumers is provided by single-phase ([[en:hiq_hw:pm1-e-d|PM1-E-D]]) and three-phase ([[en:hiq_hw:pm3-i-d|PM3-I-D]]) power sensors which are connected directly to HEMS master controller [[en:hiq_hw:mc-230|MC-230]]. It supports: 
-  * **1 grid** power sensor 
-  * up to **3** sensors for local power **plants** (PV, Wind, Cogeneration, Generator, etc) 
-  * up to **2** local **storage** systems (home battery) 
-  * up to **4** managed **consumers** (electrical heating, electrical water heater, washing machine, tumble dryer, ...) 
- 
-===== Power relays ===== 
- 
-Are used for control of managed consumers. Power relays are toggling power supply or enabling signal for the operation of the device. They are controlled directly from HEMS master controller [[en:hiq_hw:mc-230|MC-230]]. 
- 
-===== Push buttons ===== 
- 
-Are used for manual control of managed devices. Push buttons are directly wired to HEMS master controller [[en:hiq_hw:mc-230|MC-230]]. 
- 
-{{:hiq_energy:hems:hems_g2_sch.png?direct&600|}} 
- 
- 
  
en/ms_main/hiq_lighting/introduction.1587198845.txt.gz · Last modified: 2020/04/18 08:34 by marjan_strnad