Differences

This shows you the differences between two versions of the page.

--- en:robotina_charger:commissioning:power_sensor [2022/12/14 15:11] – [Add power sensor] gdzampo
+++ en:robotina_charger:commissioning:power_sensor [2022/12/20 08:14] (current) – removed gdzampo
@@ Line 1: / Line 1: @@
-==== Add power sensor ====
-<WRAP column 450px>
-Default address on all power sensor is 149.\\
-Available addresses for sensors are listed in table.\\
-\\
-**Note**: adding is supported one by one.
-</WRAP>
-<WRAP column 270px>
-|< 100% 40% 60% >|
-^ Address ^ Power sensor position|
-| 150 | Grid |
-| 154,155,156 | PV |
-| 157,158 | Battery storage |
-| 161..167 | Consumer |
-</WRAP>
-=== One-phase sensor PM1-E-D ===
-  *   Wire it to communication bus,
-  *   press and hold the push-button on the power sensor until it appears **-SEt-** on display,
-  *   it should appear in configurator as new device, click on button **add** next to the source or consumer where sensor should be assigned,
-  *   repeat procedure for next PM1-E-D.
-=== Three-phase sensor PM3-E-D ===
-  * **Connect** communication bus (to only one power-sensor)
-  * In HEMS Configurator power-sensor should appear as a "new device"
-  * Click on the **" add"** button next to the source or consumer that the sensor is measuring
-  * Connect communication bus to the next power-sensor and repeat procedure
-**Note**: It is possible to set address manually - before adding power sensor to communication bus.Allowed addresses are 150,154,161-167.
-=== Without grid power sensor ===
-  *   **Virtual grid PS** is an option if no grid meter is used. Power, current and energy will be calculated from other power sensors.
-==== Power-sensor removing ====
-=== One-phase sensors PM1-E-D ===
-  * Make sure the "new device" is empty
-  * Press the button on power-sensor until **-Set-** appears on the display
-  * In HEMS Configurator press **"del"** button next to the sensor
-  * After a few seconds, the sensor should appear as the "new device"
-  * If desired, the sensor can be removed or it can be assigned to another device
-=== Three-phase power-sensor ===
-  * Make sure the "new device" is empty
-  * In HEMS Configurator press **"del"** button next to the sensor
-  * After a few seconds, the sensor should appear as the "new device"
-  * If desired, the sensor can be removed or it can be assigned to another device
-<WRAP pagebreak></WRAP>