Differences

This shows you the differences between two versions of the page.

--- en:robotina_charger:commissioning:power_sensor [2022/12/15 09:15] – gdzampo
+++ en:robotina_charger:commissioning:power_sensor [2022/12/20 08:14] (current) – removed gdzampo
@@ Line 1: / Line 1: @@
-==== Power sensor management ====
-<WRAP column 450px>
-Default address on all power sensor is 149.\\
-Available addresses for sensors are listed in table.\\
-\\
-</WRAP>
-<WRAP column 270px>
-|< 100% 40% 60% >|
-^ Address ^ Power sensor position|
-| 149 | Default |
-| 150 | Grid |
-| 154,155,156 | PV |
-| 157,158 | Battery storage |
-| 161..167 | Consumer |
-</WRAP>
-<WRAP clear></WRAP>
-**Add** power sensor procedure:
-  *   wire it to communication bus,
-  *   only for PM1-E-D: press and hold the push-button on the power sensor until it appears **-SEt-** on display,
-  *   it should appear in configurator as new device, click on button **add** next to the source or consumer where sensor should be assigned,
-  *   repeat procedure for next.
-**Note 1**: Adding of power sensor is supported one by one.\\
-**Note 2**: PM3-E-D supports address setting manually on its display before adding it to communication bus.
-{{hiq_energy:robotina_charger:hems_add_ps.png?direct&600}}\\
-**Del** power sensor procedure:
-  * make sure **new device** is empty,
-  * only for PM1-E-D: press and hold the push-button on the power sensor until it appears **-SEt-** on display,
-  * press **del** button next to the sensor,
-  * after a few seconds, the sensor should appear as the **new device** (as on image above),
-  * sensor can be physically removed or it can be assigned to another device.
-**Note**: After **del** power sensor has default address 149.\\
-{{hiq_energy:robotina_charger:hems_del_ps.png?direct&600}}
-=== Without grid power sensor ===
-  *   **Virtual grid PS** is an option if no grid meter is used. Power, current and energy will be calculated from other power sensors.