✎ en:sg3:installations []

You've loaded an old revision of the document! If you save it, you will create a new version with this data.

====== Typical installations ======

===== Small shop, pharmacy =====

==== Requirements ====

* limited number of visitors
  * one passage for access and exit
  * automatic door
  * required temperature measurement
  * required disinfection

==== Installation ====

* SGate is installed at the entrance from the outside of the automatic door.
  * Entry detection sensors are mounted on one of the sides or on an additional carrier depending on the physical layout of the SGate relative to the door..
  * The automatic door opening signal is connected to the SGate and in parallel to the internal automatic opening sensor.
  * The staff has a wireless button to confirm alarms or to open the door manually in case of exceptions.

==== Settings ====

===== Department store =====

==== Requirements ====

* limited number of visitors
  * one-way entrance with swing gate
  * separate exit
  * required temperature measurement
  * required disinfection
  * staff can access it by scanning the code even when the count limit 1 is exceeded
  * staff do not need to scan the temperature 4 hours after a successful scan
  * hand disinfection is not mandatory for employees

==== Installation ====

* SGate is installed at the entrance from the outside of the swing gate.
  * Entry detection sensor is mounted on side of SGate or on an additional carrier depending on the physical layout of the SGate relative to the gate.
  * Security guard has a wireless button to confirm alarms or to open the door manually in case of exceptions.

==== Settings ====

=== Staff code ===

===== Offices =====

==== Requirements ====

* number of visitors not limited
  * one passage for access and exit
  * automatic door
  * required temperature measurement
  * employees do not need to scan the temperature 4 hours after a successful scan
  * required disinfection
  * required authentication with code for employees and guests
  * guests are exceptionally allowed to enter with confirmation of the reception (without code)

==== Installation ====

* SGate is installed at the entrance from the outside of the automatic door.
  * Entry detection sensor is mounted on side of SGate or on an additional carrier depending on the physical layout of the SGate relative to the door.
  * Receptionist has a wireless button or PC application to confirm alarms or to open the door manually in case of exceptions.
  * Upon booking a meeting, each guest receives a QR code, which is time limited.

==== Settings ====

=== Employee code ===

=== Guest code ===

===== Health Center =====

==== Requirements ====

* visitors can enter only at a specified time
  * one passage for access and exit
  * automatic door
  * required temperature measurement
  * required disinfection

==== Installation ====

* SGate is installed at the entrance from the outside of the automatic door.
  * Entry detection sensors are mounted on side of SGate or on an additional carrier depending on the physical layout of the SGate relative to the door.
  * Receptionist has a wireless button to confirm alarms or to open the door manually in case of exceptions.
  * Upon booking, each visitor receives a QR code, which is time limited.

==== Settings ====

=== Guest code ===

Edit summary

Note: By editing this page you agree to license your content under the following license: CC Attribution-Share Alike 4.0 International