====== TOF sensor setup ======

TOF sensor must be installed facing down above entrance to the area you want to count people in or out of. The counter works by detecting when a person crosses an invisible count line that has been configured in settings.

To access these setting, type http://x.x.x.x/login in browser; x.x.x.x being the device's IP address. On the site, login is required. When inside, the Summary menu opens. 

{{:en:3s:tof1.png?1000|}}

Change the menu to Settings. Select the Counting sub-menu. This menu is for configuring counting functionality. To enable moving the lines, enable Edit mode in the upper left corner.

{{:en:3s:tof2.png?1000|}}

Configure the count lines so that people are counted accurately. When positioning the lines, always ensure that there is enough ‘initialisation’ space for the counter to recognise a person and start tracking them – lines should be positioned away from the edge of the field of view.

To position and shape the lines:

|-First enable Line Editing Mode|
|-Click and drag on a straight part of a line to move the whole line.|
|-Click on large end or middle ‘drag’ point to move just that point.|
|-Click on a small point on a line to create another drag point.|
|-Hold CTRL and click on a drag point to delete it.|
|-In standard door counting applications it is recommended to position the lines around the door in a U or arc shape. To avoid counting ‘cross traffic’ ensure that the correct count mode is selected.|

In most cases lines configured for IN and OUT should be positioned in the same position and configuration with only the direction reversed.

Advanced features of TOF sensor allow: 

|-Staff detection. Detection is passive, all employees need to do is wear a special lanyard.|
|-Staff call and attend. Automated alerts for staff members can be raised when customers are detected waiting.|
|-Dwell time monitoring. The length of time customers spend in defined zones can be measured and reported.|
|-Height measurement and filtering. Height is measured accurately to +/- 2cm and can be used to set filters, for example exclude children and just count adults.|