====== HIQ Access configurator ======

===== Codes management =====

<WRAP column 500px>

|< 100% 150px >|
^ Edit code           | Edited code, click to enter new code  |
^ Type                | Edited code type, click to select desired type  |
^ Access points AP-ID | Access points rights for edited codes (0=no access, 255=unlimited passages, 1..245= limited passages count, decrements with every passage grant).  |
^ Active on           | Active time for edited code, use arrows to increment/decrement values, click on value to directly enter value or use buttons [ now ] or [ clear ]. Enter all 0 for no expire.  |
^ Expire on           | Expire time for edited code, use arrows to increment/decrement values, click on value to directly enter value or use buttons [ now ] or [ clear ]. Enter all 0 for no expire.  |
^ [ now ]             | Set actual date / time for expire.  |
^ [ clr ]             | Clear expire (code newer expire).  |
^ [ search ]          | Search for edited code in code list.  |
^ [ save ]            | Save edited code to list.  |
^ [ clear ]           | Clear all edited code fields.  |
^ [ delete ]          | Delete edited code from list.  |
^ Code list           | Controller codes list. Click on code to edit it.  |

</WRAP>

<WRAP column 900px>

{{:en:access:pasted:20210108-151537.png?direct&800 |}}

</WRAP>
<WRAP clear></WRAP>

===== Access events list =====

<WRAP column 500px>

|< 100% 150px >|
^ date          | event date          |
^ time          | event time          |
^ event         | event code          |
^ event data    | event data          |

</WRAP>

<WRAP column 900px>

{{:en:access:02_log.png?direct&800 |}}

</WRAP>
<WRAP clear></WRAP>

===== Access settings =====

<WRAP column 500px>

|< 100% 150px >|
^  Code readers settings                                                                                ||
^ Code                     | Code read by reader, click for manual entry                                 |
^ R-ID                     | Reader ID; link reader to access point ("show" or lock)                     |
^ Type                     | Access point type (- / Master ADD / Master All), click to toggle            |
^ State                    | State of access point.                                                      |
^  Access points settings                                                                               ||
^ AP-ID                    | Access point ID; link to code rights                                        |
^ Show: R-ID               | Link to reader ID; link to the reader for signaling the access point        |
^ Show: OUT                | Show output (click to toggle)                                               |
^ Show: Tout               | Show time-out                                                               |
^ Lock: R-ID               | Link to reader ID; link to the reader for unlocking the access point        |
^ Lock: OUT                | Lock output (click to toggle)                                               |
^ Lock: Tout               | Lock time-out                                                               |
^  General settings                                                                                     ||
^ Master code              | Master code for auxiliary code management                                   |
^ [ Parameters init ]      | Click to initialize all parameters to factory defaults                      |
^ [ Parameters save ]      | Click to save all parameters to permanent memory                            |
^ [ Parameters read ]      | Click to read all parameters from permanent memory                          |
^ Access HW modules        | Detected modules are displayed unmasked.                                    |
^ [ Autodetect ]           | Press to find HIQ Access controller in local network.                       |

</WRAP>

<WRAP column 900px>

{{:en:access:pasted:20210108-153905.png?direct&800 |}}

</WRAP>
<WRAP clear></WRAP>