====== Manufacture ======

===== MC-230 =====

Upload FW: {{ :hiq_energy:hems:methods_resources:hems_v1.0.2.cyp | FW HEMS v1.0.2}}
===== Power-sensors =====

Modbus settings for supplied power-sensors: **9600 8n2; ID: 149**

==== PM1-E-D and PM3-E-D ====

Factory setting: **2400 8n1; ID: 1; Ct: 5**

<wrap hi>Put power-sensor (PM1-E-D) in set mode by pressing button until **-SET-** is displayed on power-sensor display.</wrap>

|   Parameter        |  Address (hex)  |  Format  |  Default value (hex)     |    New value (hex)         |
| Parity / Stop bits |  40019 (00 12)  |  float   |  0 (00 00 00 00) = n1    |    3 (40 40 00 00) = n2    |
| Sensor ID          |  40021 (00 14)  |  float   |  1 (3F 80 00 00) = 1     |  149 (43 15 00 00) = 149   |
| Baud Rate          |  40029 (00 1C)  |  float   |  0 (00 00 00 00) = 2400  |    2 (40 00 00 00) = 9600  |
| Ct- Primary cuurent|  40051 (00 32)  |  float   |  5 (40 A0 00 00) = 5     |   50 (42 48 00 00) = 50 or 100 (42 C8 00 00) = 100 |

CyBro-2-230-E configuring SW: {{ :hiq_energy:hems:methods_resources:eastron_config.zip |}}

==== PM3-I-D ====

Power-meters are supplied according to our specifications - no configuration needed before sending.