====== Motion sensor ======

**Passive infrared detector on wall or ceiling**

<WRAP column 325px>

{{:en:ms_main:ir-a6-iq.png?400|}}

</WRAP>

<WRAP column 430px>

| Model number: ^ IR-A6-SA                               |
| Connects to:  | lighting circuit                        |
| Mounting:     | On wall or ceiling                     |

\\
===== Applications =====
  * Motion detector 
  * Ready light 
  * Intrusion detector
  * Lighting control
  * Hotel GRMS  

</WRAP>

<WRAP clear></WRAP>
\\
===== Features =====
  * Aestetical look
  * Easy mount

<WRAP pagebreak></WRAP>

\\
===== Installation instruction =====

  * Do not install the detector at position which faces direct or reflected sunlight or near windows with direct car headlight.

  * Ensure that there are no obstructions (plants, screens, furniture etc.) in the field of view that may cause incorrect cover/operation of the detector.

  * Avoid locating the detector in areas that contain equipment that may change the environment temperature rapidly (i.e. above radiator or under the air-conditioner)

  * Install the detector at proper height on a rigid surface. Do not install the detector on vibrating surface.

  * PIR detector is more sensitive to the motions “across” the detection zones than “toward” or “away”.

\\
===== Detection pattern =====

{{:en:ms_main:hw:ir-c6-iq_pattern.png?550|}}

<WRAP pagebreak></WRAP>

===== Range =====
{{:en:ms_main:ir-ac6-lc_range.png?550|}}



===== Technical specifications =====
| Power supply 	  |                                       230 VAC|
| Temperature 	  |                                 -20°C ~ 40°C|

\\
===== Terminals =====
| Power supply       ^  L   | Power supply    |  
| :::                ^  N   | :::             |  
| Lighting  ^  L OUT   | Lighting circuit  |  

\\

<WRAP pagebreak></WRAP>

===== Dimensions and mounting =====

{{:en:ms_main:mounting.png?400|}}


1. Separate the bottom-stand from the sensor body by turning it clockwise against the sensor body.

2. Pull the wires through the hole in the middle of the bottom-stand.

3. Fix the bottom-stand on the selected location with two screws as shown on the drawing.

4. Connect the wires.

5. Fix the sensor body on the bottom-stand and turn anti-clockwise.