en:hems_v1_2_0:methods_resources:firmwareupdate
This is an old revision of the document!
Table of Contents
Firmware update
CyBroBinLoader software
- Download latest CyBroBinLoader.exe from www.cybrotech.com
- Run CybroBinLoader.exe
- In case Windows OS is blocking execution, click on more info and run anyway
Firmware upload
- Download latest HEMS firmware from: en:hems_v1_2_0:download
- Select correct Cybro NAD (sticker on top of MC controller)
- Select firmware under PLC program
- Enable PLC program and Start PLC
- Click send
Do not interrupt durring update process
Installation and mounting
- Carefully open WM-1 module and configure serial communication with jumpers. (Default configuration is 9600bps, 8N1 with normal timeout)
- Place WM-1 module at least 10cm from other objects. Installation is not recommended inside metal cabinets.
- Connect RS485 terminals to WM-1 RS485 terminals
- A - A
- B - B
- C - GND
- Connect to 230V power supply
- Configure radio pairing
en/hems_v1_2_0/methods_resources/firmwareupdate.1635413853.txt.gz · Last modified: 2021/10/28 09:37 by neoxy