✎ en:hiq_hw:cad-232-a2-iq []

You've loaded an old revision of the document! If you save it, you will create a new version with this data.

====== Serial converter ======

**RS232 to RS485 converter**

</WRAP>

===== Applications =====

* Connecting power sensor and other RS-485 devices to HC/MC (Home Controller/Master Controller)

</WRAP>

===== Installation =====

* :!: Place CAD-232-A2-IQ module on DIN rail next to Home Controller
  * Connect enclosed red cable between COM1 port on Home Controller and one of RS232 port at bottom side of CAD-232-A2-IQ module
  * Connect RS485 terminals to SDM-120-C RS485 terminals
    * A - A
    * B - B
    * C - GND

===== Features =====

*  2 x RS232 channel
  * galvanic isolated A-bus lines from RS232
  * LED signalization for data flow
  * push and click mounting on DIN rail
  * small dimensions
  * removable RS485 terminal
  * 24V DC powered over IEX-2 bus

===== General description =====

**Power meter converter** is RS232 to RS485 converter used to connect [[hiq_building_automation:hiq_home:hw:sdm120c|SDM120C]] power meter to Home Controller.

===== Technical specification =====

| Power supply:          |                                24V/50mA |
| Galvanic isolation:    | RS485 is galvanic isolated from circuit |
| Ingress protection:    |                                    IP20 |
| Operating temperature: |                                 0..50°C |
| Storage temperature:   |                               -20..75°C |
| Relative humidity:     |                              0..85% n/c |

===== Terminals =====

| To power meter ^ A | RS485 bus  |
| :::            ^ B | :::        |
| :::            ^ C | :::        |

Edit summary

Note: By editing this page you agree to license your content under the following license: CC Attribution-Share Alike 4.0 International