en:hiq_hw:wm-1
This is an old revision of the document!
Table of Contents
Wireless Modbus-to-Modbus bridge
Wireless Modbus-to-Modbus bridge
| Model number: | WM-1 |
|---|---|
| Frequency: | ISM 868MHz (EU) |
| Dimensions: | 93x45x27 mm |
Applications
- Replacement for RS485 wiring solution with wireless. Optimal for long range Modbus RTU serial communications with half duplex configuration.
Installation
Carefully open WM-1 module and configure serial communication with jumpers. (Default configuration is 9600bps, 8N1 with normal timeout)- Place WM-1 module at least 10cm from other objects. Installation is not recommended inside metal cabinets.
- Connect RS485 terminals to WM-1 RS485 terminals
- A - A
- B - B
- C - GND
- Connect to 230V power supply
- Configure radio pairing
Features
- replacement for RS485 wiring
- Modbus RTU serial protocol
- wired/wireless combinations
- very long range, no hopping
- protected private connection
- multiple slaves per device
- multiple addressable groups
Technical specification
| Power supply: | 230V, 50/60Hz, 1W |
| Ingress protection: | IP20 |
| Operating temperature: | -20..50°C |
| Storage temperature: | -40..85°C |
| Relative humidity: | 0..85% n/c |
Terminals and wiring
| To power sensor | A | RS485 bus |
|---|---|---|
| B | ||
| C | ||
| To power supply | L | 230V AC |
| N |
Radio configuration
Create new secure group
* turn on all devices as the same time * within 10 seconds, while RF LED is blinking, press and hold button on one of the devices * after a second, the new address is randomly generated and sent to all devices. RF LED will blink 3 times to confirm the new address.
en/hiq_hw/wm-1.1634737254.txt.gz · Last modified: 2021/10/20 13:40 by neoxy